Build Your shops Own Custom Sparkling Coil Cable- Triple Sleeved

PLEASE NOTE THIS PRODUCT ONLY INCLUDE KEYBOARD CABLES (KEYBOARDS, KEYCAPS AND PROP ARE ONLY FOR DISPLAY ONLY)

Our cables are carefully crafted with attention to details. Some photos of my soldering works can be found here . All cables are reversed coiled and oven baked for a total of 120 minutes (not including freezing and resting overnight) to produce perfectly tight and springy coiled cables. With that being said, all cables should be treated with love and care.
After your order is placed, please send me a message with the following details:

1. USB Connector Type for host side (PC)

Options:
Type A - default
Type C

2. USB Connector Type for device side (keyboard)

Options:
Type Micro
Type C - Default
Type B mini

3. Coil length default is 7 inches and can be adjusted per request (Additional cost might be required for extra length)

4. Coil diameter is 1/2 inches

5. Host length default is 4 feet and can be adjusted per request (Additional cost might be required for extra length)

6. Device Power shortage warning:

If your keyboard requires more than average power (a lot of LEDs/RGB etc.) I recommend 4 feet or less for the extension.

For high powered keyboards such as Massdrop's CTRL/ALT, HHKBs, Ducky One2Mini, and Input Club's K-Type I recommend 4 feet or less for the extension (7'' coil length or less). Anything longer than that could potentially cause disconnecting or low power brightness for your board.

IF YOU ARE USING ONE OF THE HIGH POWERED BOARDS, I NEED TO KNOW! PLEASE TELL ME WITH THE REST OF THE INFORMATION.

Please keep in mind, that unless stated otherwise the coil in the cable will be before the aviator connector. So the default shops layout will be as follows: USB (PC) > cable length > aviator connector > coil > USB (keyboard).

If you have any other questions or concerns, please note them in the message. Thanks!